Vizio IR Sensor Replacement - 3637-0022-0189
CLICK HERE For Parts: www.shopjimmy.com/catalogsearch/result/?q=3637-002…

JVC TV Models:
JLE32BC3001
JLE47BC3500
JLE47BC3001
JLE42BC3500
JLE42BC3001
JLE37BC3001

Vizio TV Models:
E3D470VX LATKJZEN
E3D470VX LAUKJZAM
E3D470VX LAQKJZEN
M420SV
M3D651SV
M470SV LAUKJYAM
M3D650SV LAEAMEAN
E3D420VX LAQKJXEN
E3D420VX LAQKJXAM
E3D420VX LATKJXEN
E3D420VX LAUKJXAM
E3D320VX LAQKJRDN
E3D320VX LAUKJRAM
M550SV LAUPKAAM
M550SV LAQPKAAM

This video is designed to be a guide. Please note that other complications may exist that aren't addressed in this guide. While we always strive to provide accurate and detailed information, we can't guarantee that it will fix your TVs issues.
ShopJimmy is not responsible for any harm that you may cause to yourself or damage to your TV during the repair process. Try all repairs and troubleshooting at your own risk.
Be sure to take all of the proper safety precautions.
In this video we will show how to replace the 3637-0022-0189 IR sensor. The IR sensor receives the signal from the remote control and sends the request to the main board. If your remote control is not working with your TV, there are a few tests that you can run to determine if your remote control is working or not.
Using the camera on your cell phone or a video camera, point the remote at the camera, look through the viewer for the camera, and then press a button repeatedly on the remote and see if you can see the light flashing on the front of the remote.
If you can see the light, then you know your remote control is working and there is most likely a problem with your IR sensor. If you cannot see the light, then it is recommended to replace the batteries in your remote and test again.
After replace the batteries, test again through the camera. If you still cannot see the light, then there is a problem with the remote, but if you do see the light, then your remote is good and there is most likely a problem with the IR sensor, and it should be replaced.
We will start by removing the back cover off the TV.
The IR sensor for this TV is located in the lower right corner. We have put a red box around the area.
Our TV in this video is a tester, so we do not have any screws in some places that your TV might have screws, but we will still go through the motions of removing the screws for the tutorial.
Remove the screws on the keypad controller and then gently lift it away from the IR sensor.
Remove the screws on the IR sensor.
Carefully lift the IR sensor and disconnect the cable.
Using the replacement IR sensor, reconnect the cable and put it back into place.
Install the screws.
Align the keypad controller and insert the screws.
Install the back cover on the TV and test the IR sensor with your remote.

TV Repair Made Easy™
© 2016 ShopJimmy.com, LLC.